Georgia DDS CDL General Knowledge Practice Test 4
Test 4 of 5. Pick an answer for each question to see if it is right and why; your score appears at the end. You need 40 correct answers to pass, the same ratio as the real Georgia test.
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. Within total stopping distance, what exactly is perception distance?
Show answer
Answer D: The distance traveled from the moment your eyes see a hazard until your brain identifies it
Perception distance covers only the time between seeing a hazard and recognizing it as a hazard, before any physical reaction begins.
-
2. How soon after a Georgia commercial learner's permit is first issued may the holder take the CDL skills test?
Show answer
Answer A: Not until 14 days have passed
A commercial learner's permit holder in Georgia is not eligible to take the CDL skills test during the first 14 days after the permit is first issued.
-
3. You are loading lengths of large diameter pipe on a flatbed. What is needed besides the tiedowns?
Show answer
Answer D: Chocks, wedges or cradles that keep the pipe from rolling
Anything that can roll must be prevented from rolling by chocks, wedges, cradles or a similar device that is itself secured so it cannot come out.
-
4. Why does a cracked frame rail or cross member make a vehicle unsafe?
Show answer
Answer B: The frame carries the whole load, and a crack can spread until the structure fails
The frame is the backbone that supports the body, the load and the running gear, so a crack in it is a structural failure that grows with every mile.
-
5. You are backing with a helper guiding you and the helper drops out of sight in your mirror. What should you do?
Show answer
Answer B: Stop until you can see the helper again
If you cannot see the helper you cannot receive a signal to stop, so the only safe action is to halt until visual contact is restored.
-
6. A sign before a long descent shows 6 percent. What does that number tell you?
Show answer
Answer A: How steep the grade ahead is
Percent grade is the drop in feet for every hundred feet of road, so the higher the number the faster speed will build and the lower the gear you need.
-
7. After starting a trip, when must a driver first re-inspect the cargo and the devices holding it?
Show answer
Answer A: Within the first 50 miles
Federal rules require a check of the load and its securement within the first 50 miles, because settling and vibration loosen straps and chains early in a trip.
-
8. Why can an empty truck need a longer stopping distance than a loaded one?
Show answer
Answer C: An empty vehicle has less traction, so its wheels lock up more easily
Brakes and tires are designed for a loaded vehicle, and with little weight on the axles the tires grip less and lock sooner.
-
9. Around a tractor-trailer, where are the blind areas that other drivers most often sit in unseen?
Show answer
Answer A: Along the right side and directly behind the trailer
The blind areas to the right of the cab and behind the trailer are the largest, which is why other drivers should never linger there.
-
10. What does it mean to overdrive your headlights at night?
Show answer
Answer D: Driving so fast that you cannot stop within the distance lit by your headlights
You must be able to stop inside the distance you can see; at night that distance is limited by the headlights, so speed must be lowered to match.
-
11. What should you do before backing into a space you have not used before?
Show answer
Answer A: Get out and walk around to check the path, the clearance and any obstacles
Walking the area first reveals low obstructions, soft ground and objects that never appear in the mirrors.
-
12. You drop your phone on the floor of the cab while driving. What do federal rules require?
Show answer
Answer A: Leave it, because reaching for it while driving is banned
Federal rules forbid reaching for a mobile device in any way that takes the driver out of a seated, belted driving position.
-
13. Which of these counts as a serious traffic violation for a commercial driver license holder?
Show answer
Answer C: Speeding 15 miles per hour or more above the limit
Excessive speeding, reckless driving, improper lane changes, following too closely and texting while driving are all serious traffic violations.
-
14. How should a commercial driver treat the speed posted for a curve?
Show answer
Answer B: As a limit set for cars in good conditions, so a heavy or tall load calls for a lower speed
Posted curve speeds are based on passenger vehicles in good conditions, and a tall or heavy load can roll over well below that speed.
-
15. Which brake lining condition must be reported?
Show answer
Answer C: Linings that are worn thin, loose, cracked or soaked with oil or grease
Linings must have enough material left and must be securely attached and clean, because a thin, loose or contaminated lining cannot deliver its share of braking.
-
16. How does a typical escape ramp stop a runaway vehicle?
Show answer
Answer B: With a bed of loose gravel or sand, often on an upgrade
Escape ramps use deep loose material, usually combined with a rising grade, so the vehicle is slowed gradually instead of being stopped by impact.
-
17. Why must tiedowns be rechecked during a trip even when they were tight at the start?
Show answer
Answer C: Road vibration and cargo movement can loosen them as the miles go by
Straps and chains settle and loosen as the vehicle bounces and the cargo shifts slightly, so the load must be rechecked at the required intervals.
-
18. How does the working load limit of a tiedown relate to the force that would break it?
Show answer
Answer B: The working load limit is a fraction of the breaking strength and is the figure you use
The working load limit is set well below the point at which the device would fail, and securement is always calculated from the working load limit, never from breaking strength.
-
19. Why does the commercial driver manual tell you to look far down the road instead of only at the vehicle ahead?
Show answer
Answer D: So you can adjust smoothly instead of braking hard at the last moment
A heavy vehicle cannot react quickly, so early information lets you slow gradually rather than make a sudden stop or swerve.
-
20. The paperwork shows a weight, but the load looks heavier than you expected. What should you do?
Show answer
Answer C: Weigh the vehicle, since you are the one answerable for driving it overweight
The driver is the one who can be cited for an overweight vehicle, so a doubtful weight is settled on a scale before the trip continues.
-
21. Why should both outside mirrors be checked over and over while backing?
Show answer
Answer B: Each mirror covers only part of the path and neither covers the blind spots, so people and objects can appear without warning
Working both mirrors in turn is the only way to follow the whole path of a vehicle you cannot see behind.
-
22. Federal rules say a commercial vehicle may not be driven unless what is true of its cargo?
Show answer
Answer B: It is properly distributed and adequately secured
The basic federal requirement is that the load be distributed properly and secured well enough that it cannot move, whatever the paperwork says.
-
23. Two tires in a dual set have noticeably different diameters. Why is that a problem?
Show answer
Answer C: The larger tire carries more than its share of the load and can be overloaded
The taller tire touches the road first and takes most of the weight, so it runs overloaded and hot while the smaller one does little work.
-
24. Your vehicle begins to hydroplane on a wet road. What should you do?
Show answer
Answer B: Release the accelerator and push in the clutch so the wheels can turn freely and regain grip
Hydroplaning tires are riding on water; slowing without braking lets them settle back onto the road and grip again.
-
25. During the vehicle overview, what should the driver look for on the ground under the vehicle?
Show answer
Answer B: Fresh puddles of oil, coolant, grease or fuel
New stains on the ground are the earliest sign of a leak, so the overview includes a look underneath before anything is opened or started.
-
26. Under Georgia rules, where are commercial motor vehicles and other vehicles with more than six wheels generally prohibited?
Show answer
Answer D: Along GA 400 and interstate routes inside I-285, except for local pickup or delivery, terminal, repair or residence trips
Georgia bars these vehicles from GA 400 and interstate routes inside the arc of I-285 unless the driver is making a pickup or delivery, traveling to or from a terminal or repair facility, or traveling to or from a residence inside that arc.
-
27. When turning left, what should a driver of a long vehicle do before beginning the turn?
Show answer
Answer B: Reach the center of the intersection so the rear wheels clear the corner
The rear wheels follow a tighter path than the front, so the vehicle must reach the center of the intersection before the turn begins.
-
28. Which lights should be used in fog, by day or by night?
Show answer
Answer A: Low beams and fog lights, together with the four-way flashers
High beam light bounces back off the water droplets and makes seeing worse, while low beams, fog lights and flashers help you see and help others see you.
-
29. A tire may be regrooved only when what is true?
Show answer
Answer B: It carries a marking from the manufacturer showing that it is regroovable
Only casings built with extra rubber under the tread and marked regroovable by the manufacturer may be cut, because others would be grooved into the belts.
-
30. When should a driver select the gear for a long, steep downgrade?
Show answer
Answer B: Before starting down the grade
The low gear has to be chosen before the descent, because a heavy vehicle gaining speed may refuse to shift down at all.
-
31. Which shock absorber condition is a defect?
Show answer
Answer C: A shock that is leaking, broken or disconnected at either mounting
A shock that has lost its fluid or its mounting no longer damps the suspension, so the wheel bounces and loses contact with the road.
-
32. How long must a motor carrier keep a driver vehicle inspection report and the certification of repairs?
Show answer
Answer B: Three months
The original report and the certifications attached to it are kept on file for three months from the date the report was prepared.
-
33. How do you avoid the sharp lurch that comes at the very end of a stop in a heavy vehicle?
Show answer
Answer A: Ease off the brake pressure just before the vehicle actually comes to rest
A smooth stop is finished by reducing pedal pressure as the vehicle settles, so the suspension does not rock the cab and the load forward.
-
34. How are the headlights, marker lights and turn signals checked during the seven-step inspection?
Show answer
Answer A: The engine is shut off, the parking brake is set, the lights are switched on and then checked from outside the vehicle
The lights are switched on with the vehicle secured, then the driver walks around and confirms each lamp actually works and is clean.
-
35. What extinguisher rating is required on a vehicle carrying hazardous materials in amounts that need placards?
Show answer
Answer B: 10 B:C or more
Placarded loads carry a much higher fire risk, so the required extinguisher rating rises to at least 10 B:C.
-
36. How does a load carried high in the trailer affect safe speed through a curve?
Show answer
Answer B: It raises the rollover risk, so the speed must be lower
A high center of gravity lets the vehicle tip long before the tires lose their grip, so height of the load directly limits curve speed.
-
37. What is the correct way to test the parking brake before a trip?
Show answer
Answer C: With the parking brake set, put the vehicle in a low gear and gently try to move forward
A parking brake that holds against a gentle pull in low gear is working; if the vehicle moves, the brake needs adjustment or repair.
-
38. At a rest area you find that the load has shifted although the straps still feel tight. What should you do?
Show answer
Answer C: Correct the load before driving on, since a shifted load is no longer secure
Movement means the securement has already failed once, and a load that has shifted can shift again, so it is put right before the vehicle moves.
-
39. The brake pedal goes to the floor in a vehicle with hydraulic brakes. What can you do to build some braking pressure?
Show answer
Answer B: Pump the brake pedal rapidly, which may bring back enough pressure to slow the vehicle
Pumping can restore some hydraulic pressure; along with downshifting and the parking brake it is one of the ways to stop when the pedal fails.
-
40. What does the gross vehicle weight rating of a vehicle describe?
Show answer
Answer A: The maximum loaded weight of that single vehicle, as specified by the manufacturer
The rating is the manufacturer figure for the loaded weight of one vehicle, so it is a limit fixed in advance rather than a measurement of the load on board today.
-
41. Part of looking well ahead is planning an out. What does that mean?
Show answer
Answer B: Keeping an escape path in mind in case traffic stops suddenly
Because a heavy vehicle often cannot stop in time, good drivers continuously note where they could steer if the space ahead closes.
-
42. For a modern truck with low-friction parts and a streamlined shape, which gear should be used going down a grade?
Show answer
Answer D: A gear lower than the one needed to climb the same grade
Newer trucks roll more freely than older ones, so the old rule of using the climbing gear no longer holds; a lower gear is needed for enough engine braking.
-
43. May a commercial driver use a hand-held phone while stopped at a red light?
Show answer
Answer B: No, a stop in traffic still counts as driving
Hand-held use is allowed only when the vehicle has been moved to the side of or off the highway and halted where it can safely remain stopped.
-
44. Why must cargo also be held down against vertical movement and not only against sliding?
Show answer
Answer D: Because a load that bounces can jump the blocking and slacken its own tiedowns
Rough road makes an unrestrained article lift; every bounce lets it move a little and works the tiedowns loose until nothing is holding it.
-
45. The scale shows that your combination is over the legal gross weight. Why will sliding the tandems not fix it?
Show answer
Answer B: Because sliding the axles changes where the weight sits, not how much there is
Repositioning axles redistributes weight between axle groups; when the total is too high, freight has to come off the vehicle.
-
46. A fire has started in the vehicle. How should the extinguisher be used?
Show answer
Answer B: Stay as far back as the reach of the extinguisher allows, stand upwind, and aim at the base of the fire
Aiming at the base attacks what is actually burning, and staying upwind and well back protects the driver from heat, smoke and the flames themselves.
-
47. What tells a driver when to shift up in a vehicle with a manual transmission?
Show answer
Answer C: Engine speed in rpm together with road speed
Shift points are judged from engine rpm and road speed, using the operating range the manufacturer specifies for that engine.
-
48. What are you looking for on the brake drums during the walkaround?
Show answer
Answer B: Cracks, dents and any oil or grease that has reached the friction surface
A cracked or badly scored drum can break apart under braking heat, and oil or grease on the friction surface destroys the braking effort at that wheel.
-
49. You are moving an oversized load under a permit that requires a pilot vehicle. What is the pilot vehicle there to do?
Show answer
Answer B: Warn other traffic and check the route ahead for clearances and hazards
Escort or pilot vehicles warn approaching traffic and scout the route for low bridges, narrow spots and other hazards that a wide or long load cannot pass.
-
50. A car that passed you on the right slows and stays alongside your trailer. What is the best response?
Show answer
Answer D: Ease off the accelerator so the car can move clear
A vehicle sitting beside a trailer is in a blind area and has nowhere to go if you need the lane, so the safest fix is to let it get ahead or behind.